How To Reset The Honda Airbag Module

If your Honda has been involved in a collision or has experienced airbag deployment, the airbag control module (also known as the SRS module) will store diagnostic trouble codes (DTCs) in its memory. These codes indicate that a fault has been detected in the system, and the airbags may not function properly until the issue is resolved. Resetting the Honda airbag module is an essential step in restoring your vehicle's safety features, and it's not as complicated as you might think. In this article, we'll guide you through the process of resetting the Honda airbag module and explain why it's important to do so.

What is the Honda Airbag Module?

The airbag control module is an essential component of the Honda Supplemental Restraint System (SRS), responsible for deploying the airbags in the event of a crash. The module uses various sensors throughout the vehicle to detect an impact and send a signal to deploy the airbags. The module also stores diagnostic trouble codes (DTCs) in its memory if an issue is detected in the system.

Why Reset the Honda Airbag Module?

Resetting the Honda airbag module is essential if the vehicle has been involved in a collision or has had airbag deployment. When the airbags deploy, the SRS module records the event and stores DTCs in its memory. These codes indicate that the airbag system has detected an issue and may not function properly until the problem is resolved.

In some cases, the airbag system may continue to function even with DTCs stored in the module. However, it's important to note that the system may not work as intended in the event of another collision or airbag deployment. Resetting the Honda airbag module will clear the DTCs and ensure that the system is functioning correctly.

What Tools Do You Need to Reset the Honda Airbag Module?

To reset the Honda airbag module, you'll need an OBD-II scanner and an SRS reset tool. The OBD-II scanner is used to read and clear the diagnostic trouble codes stored in the module. The SRS reset tool is used to reset the airbag module's memory and clear the DTCs.

It's important to use an SRS reset tool specifically designed for Honda vehicles to ensure that the process is done correctly. Using the wrong tool could result in damaging the airbag module or causing further issues in the system.

How to Reset the Honda Airbag Module

Now that you have the necessary tools, let's walk through the steps to reset the Honda airbag module:

Step 1: Turn off the ignition and disconnect the battery's negative terminal.

Step 2: Locate the airbag control module. In most Honda models, it's located under the passenger seat or in the center console.

Step 3: Remove the module from its mounting bracket and disconnect the electrical connectors.

Step 4: Connect the SRS reset tool to the module's electrical connectors. Follow the manufacturer's instructions on how to use the tool.

Step 5: Reconnect the electrical connectors to the module and reinstall it in its mounting bracket.

Step 6: Reconnect the battery's negative terminal.

Step 7: Use an OBD-II scanner to read and clear any remaining diagnostic trouble codes stored in the module.

Step 8: Turn on the ignition and verify that the airbag warning light on the dashboard turns off after a few seconds.